Siemens SINUMERIK 840D Series Diagnostics Manual page 207

11.02
Definitions:
Reactions:
Remedy:
Program Continuation:
15010
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
15020
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
15021
Parameters:
Definitions:
Reactions:
 Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
A WAITM/WAITMC/SETM/CLEARM instruction was programmed with a marker number
that was less than 1 or greater (MAXNUM_MARKER * MAXNUM_CHANNELS).
Exception: CLEARM(0) is allowed and clears all markers in channel!
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
Correct the instruction accordingly.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 program coordination instruction with invalid channel num-
ber
%1 = Channel number
%2 = Block number, label
A WAITM, WAITMC, INIT or START instruction was programmed with an invalid channel
number.
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
Correct the instruction accordingly.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 CHANDATA instruction cannot be executed. Channel %3 is
not active
%1 = Channel number
%2 = Block number, label
%3 = String (CHANDATA parameter)
With a CHANDATA instruction, the data input for a channel is selected that has not been
activated. For structural reasons, the input of multi-channel data must take place twice.
- Alarm display.
- Interface signals are set.
- Interpreter stop
- NC Start disable in this channel.
Please inform the authorized personnel/service department.
• Activate the channel concerned by means of machine data or option data or
• Cancel the CHANDATA instruction and all following assignments to channel data. This
error message occurs regularly when first reading in an INITIAL Init block with which a
multi-channel system is to be installed. In this case:
1. NCK Restart must be executed in order to activate the global machine data already
input for the installation of the other channels.
2. Input of the INITIAL Init block must be repeated.
Switch control OFF - ON.
Channel %1 block %2 CHANDATA instruction with invalid channel number
%1 = Channel number
%2 = Block number, label
A CHANDATA instruction is used to enter data for an illegal channel, e. g. <1,> maximum
number of channels, not the active channel.
- Alarm display.
- Interface signals are set.
- Interpreter stop
- NC Start disable in this channel.
1 Alarms
1-207