Siemens SINUMERIK 840D Series Diagnostics Manual page 403

11.02
Reactions:
Remedy:
Program Continuation:
61610
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61611
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61612
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61613
Parameters:
Definitions:
Reactions:
 Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
- Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
Check parameter for the undercut form.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 no infeed depth programmed
%1 = Channel number
%2 = Block number, label
Alarm triggered by following cycles: CYCLE76, CYCLE77, CYCLE96.
- Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
-
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 no intersection point found
%1 = Channel number
%2 = Block number, label
No intersection could be calculated with the contour. Alarm triggered by following cycle:
CYCLE95.
- Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
Check contour programming or modify infeed depth.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 thread axis cutting not possible
%1 = Channel number
%2 = Block number, label
Alarm triggered by following cycles: CYCLE97, CYCLE98.
- Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
-
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 undercut position incorrectly defined
%1 = Channel number
%2 = Block number, label
Alarm triggered by following cycles: CYCLE94, CYCLE96.
- Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
1 Alarms
1-403