Siemens SINUMERIK 840D Series Diagnostics Manual page 331

11.02
Reactions:
Remedy:
Program Continuation:
26005
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
26006
Parameters:
Definitions:
 Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
- Mode group not ready.
- Channel not ready.
- If the axis is a single axis when this alarm is triggered, the alarm is only effective for this
axis (not effective for e.g. the channel or mode group)
- Channel not ready.
- NC Start disable in this channel.
- NC Stop on alarm.
- The NC switches to follow-up mode.
- Alarm display.
- Interface signals are set.
Please inform the authorized personnel/service department. Enter the encoder grid point
distance according to the data given by the machine (or measuring device) manufacturer
in the machine data 31010 ENC_GRID_POINT_DIST.
Switch control OFF - ON.
Axis %1 parameterization error: output rating
%1 = Axis name, spindle number
The output evaluation of the analog speed setpoint set in the machine data 32250
RATED_OUTVAL or in MD 32260 RATED_VELO is zero.
The alarm can be reprogrammed in the MD ALARM_REACTION_CHAN_NOREADY
(channel not ready).
- Mode group not ready.
- Channel not ready.
- If the axis is a single axis when this alarm is triggered, the alarm is only effective for this
axis (not effective for e.g. the channel or mode group)
- Channel not ready.
- NC Start disable in this channel.
- NC Stop on alarm.
- The NC switches to follow-up mode.
- Alarm display.
- Interface signals are set.
Please inform the authorized personnel/service department. The nominal output voltage
in [%] of the maximum setpoint value (10 V) is entered in the machine data 32250
RATED_OUTVAL, at which the rated motor speed in [degrees/s] is to be reached
(machine data 32260 RATED_VELO).
Clear alarm with the RESET key in all channels of this mode group. Restart part program.
Axis %1 encoder %2 encoder type/output type %3 not possible
%1 = Axis name, spindle number
%2 = Encoder number
%3 = Encoder type/output type
Not every encoder type or output type is suitable for both the FM-NC and the 840D.
Permissible settings for 840D:
MD 30240 ENC_TYPE
= 0 Simulation
= 1 Signal generator
= 2 Square-wave encoder
MD 30130 CTRLOUT_TYPE
= 0 Simulation
= 1 Standard
1 Alarms
1-331