Siemens SINUMERIK 840D Series Diagnostics Manual page 451

11.02
Reactions:
Remedy:
Program Continuation:
111900
Definitions:
Reactions:
Remedy:
Program Continuation:
111901
Definitions:
Reactions:
Remedy:
Program Continuation:
111902
Definitions:
Reactions:
Remedy:
Program Continuation:
111904
Definitions:
Reactions:
Remedy:
Program Continuation:
112045
Definitions:
Reactions:
 Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
- Alarm display.
- -
There must be enough memory for the original sequence and for the backup copy in order
for the sequence to be created.
Internal
Start only possible in basic display
A G code program can only be started from the basic display of an operating mode
(except MANUAL).
- Alarm display.
Switch to the basic display of an operating mode (except MANUAL). Start single step
mode with NC start.
Internal
Contour is contained in the current program, machining not enabled
There is a contour in the current Easystep sequence and it is not permitted to be
changed.
- Alarm display.
Terminate machining. Reload the Easystep sequence and change it correspondingly.
Internal
Start only with valid reference point
The axes have no valid reference point.
- Alarm display.
Reference all axes.
Internal
4. Axis not configured, i.e., no driven tool possible
4. The axis is not configured, i.e., no driven tool is possible.
- Alarm display.
4. Create an axis. Hereby, the following machine data has to be changed:
• Channel-specific 20070 $MC_AXCONF_MACHAX_USED [3]=4
• Axis-specific for the 4th axis.
• 30300 $MA_IS_ROT_AX=1
• 30310 $MA_ROT_IS_MODULO=1
• 30320 $MA_DISPLAY_IS_ MODULO=1
• 30350 $MA_SIMU_AX_VDI_OUTPUT=1
• 35000 $MA_SPIND_ASSIGN_TO_MACHAX=2
Internal
Several insertion points required
Several insertion points are required for machining the contour pocket. The machining
breaks up into several individual machinings.
The program can be started.
This alarm is only a warning.
Residual material will remain.
- Alarm display.
1 Alarms
1-451