Siemens SINUMERIK 840D Series Diagnostics Manual page 107

11.02
Remedy:
Program Continuation:
10780
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
10781
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
10782
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
 Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
• Continue machining with CANCEL and Start.
• Modify part program.
• Set setting data $SC_STOP_CUTCOM_STOPRE to FALSE.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 preprocessing stop with active tool radius compensation
%1 = Channel number
%2 = Block number, label
If a preprocessing stop is detected with active tool radius compensation (either pro-
grammed by the user or generated internally) and the setting data
$SC_STOP_CUTCOM_STOPRE is set, then this warning is issued because in this situa-
tion machine movements which were not intended by the user can occur (termination of
radius compensation and new approach).
To continue machining, activate the CANCEL key and perform a restart.
- Local alarm reaction.
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
- NC Stop on alarm at block end.
• Continue machining with CANCEL and Start.
• Modify part program.
• Set setting data $SC_STOP_CUTCOM_STOPRE to FALSE.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 illegal orientation of involute with tool radius compensation
%1 = Channel number
%2 = Block number, label
Tool radius compensation is possible for involutes only if the compensation plane
matches the involute plane.
- Local alarm reaction.
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
- NC Stop on alarm at block end.
Modify part program.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 illegal curve type with tool radius compensation
%1 = Channel number
%2 = Block number, label
This alarm occurs, if an attempt is made to apply the tool radius compensation to a curve
type for which this function is not implemented. The only cause at present: Involute with
3D tool radius compensation.
- Local alarm reaction.
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
- NC Stop on alarm at block end.
Modify part program.
Clear alarm with NC START or RESET key and continue the program.
1 Alarms
1-107