Siemens SINUMERIK 840D Series Diagnostics Manual page 298

1 Alarms
20200
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
20201
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
20203
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
20204
Parameters:
Definitions:
1-298
Channel %1 invalid spindle number %2 with tool fine compensation
%1 = Channel number target channel
%2 = Spindle number
There is no spindle/axis assignment in the target channel for the spindle specified in the
PUTFTOC command.
- Alarm display.
- Interpreter stop
- Interface signals are set.
- NC Start disable in this channel.
- NC Stop on alarm.
Modify program in channel that writes the tool fine compensation.
Clear alarm with the RESET key. Restart part program
Channel %1 spindle %2 no tool assigned
%1 = Channel number
%2 = Spindle number
In order to make allowance for the fine tool compensation for the tool currently in the spin-
dle, a spindle/tool assignment must be active. This is not presently the case for the pro-
grammed spindle in the target channel of fine tool compensation.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
1. Modify the part program (write the tool fine compensation).
2. Establish spindle/tool assignment by programming:
• TMON (tool monitoring)
• GWPSON (tool selection)
Clear alarm with the RESET key. Restart part program
Channel %1 no active tool
%1 = Channel number
A tool fine compensation has been written for the active tool of channel %1 with PUTF-
TOC. No tool is active in this channel. Therefore, the compensation cannot be assign-ed.
- Alarm display.
- Interpreter stop
- Interface signals are set.
- NC Start disable in this channel.
- NC Stop on alarm.
Correct the program.
Clear alarm with the RESET key. Restart part program
Channel %1 PUTFTOC command not allowed with FTOCOF
%1 = Channel number
A tool fine compensation has been written for channel %1 with PUTFTOC. The tool fine
compensation is not active in this channel. FTOCON must be active in the target channel
of the PUTFTOC command.
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
 Siemens AG, 2002. All rights reserved
11.02