Siemens SINUMERIK 840D Series Diagnostics Manual page 390

1 Alarms
61212
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61213
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61214
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61215
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
1-390
Channel %1 block %2 wrong tool type
%1 = Channel number
%2 = Block number, label
The tool type is not suitable for machining. Alarm triggered by following cycles: CYCLE92,
CYCLE951, E_DR, E_DR_PEC, E_DR_SIN, F_DR, F_DRILL, F_DRILLC, F_DRILLD,
F_DR_PEC, F_DR_SIN, F_GROOV, F_MT_LEN, F_PARTOF, F_ROUGH, F_ROU_Z,
F_SP_EF, F_TAP, F_TR_CON, F_UCUT_T.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Select a new tool type.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 circle radius too small
%1 = Channel number
%2 = Block number, label
Alarm triggered by following cycle: CYCLE77.
- Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
-
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 no lead programmed
%1 = Channel number
%2 = Block number, label
No thread lead was entered. Alarm triggered by following cycles: E_CR_HEL, E_PO_CIR,
E_PO_REC, F_PO_CIR, F_PO_REC.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Program a lead.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 raw dimension incorrectly programmed
%1 = Channel number
%2 = Block number, label
Alarm triggered by following cycle: CYCLE76, CYCLE77.
- Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
-
Clear alarm with the RESET key. Restart part program
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
 Siemens AG, 2002. All rights reserved
11.02