Siemens SINUMERIK 840D Series Diagnostics Manual page 395

11.02
Remedy:
Program Continuation:
61238
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61239
Definitions:
Reactions:
Remedy:
Program Continuation:
61240
Definitions:
Reactions:
Remedy:
Program Continuation:
61241
Definitions:
Reactions:
Remedy:
Program Continuation:
61242
Definitions:
Reactions:
 Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
Manually retract the tool from the retraction area defined in the program header and
restart the program.
Internal
Channel %1 block %2: Machining direction unknown.
%1 = Channel number
%2 = Block number, label
-
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Please contact the responsible Siemens regional office.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2: Tool change point lies in the retraction area!
The tool change point has to be far enough outside the retraction area so that when the
revolver is swivelled, no tool extends into the retraction area.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Specify another tool change point.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2: Wrong feed type
-
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Check feed type.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2: No retraction plane defined for this machining direction.
-
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Define more retraction planes.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2: Wrong machining direction
-
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
1 Alarms
1-395