Siemens SINUMERIK 840D Series Diagnostics Manual page 175

11.02
Definitions:
Reactions:
Remedy:
Program Continuation:
14129
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
14130
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
14131
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
14132
Parameters:
Definitions:
Reactions:
 Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
The programmed rotation of tool orientation cannot be traversed.
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
Modify part program.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 orientation angles and orientation vector components pro-
grammed
%1 = Channel number
%2 = Block number, label
An orientation angle and components of an orientation vector were programmed at the
same time.
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
Modify part program.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 too many initialization values given
%1 = Channel number
%2 = Block number, label
On assigning an array by means of SET, more initialization values than existing array ele-
ments have been specified in the program run.
- Alarm display.
- Interface signals are set.
- Interpreter stop
- NC Start disable in this channel.
Reduce the number of initialization values.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 orientation axes and lead/tilt angles programmed
%1 = Channel number
%2 = Block number, label
An orientation angle and a leading or sideways angle were programmed at the same time.
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
Modify part program.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 orientation axes incorrectly configured
%1 = Channel number
%2 = Block number, label
The configuration of the orientation axes does not match the machine kinematics.
- Alarm display.
- Interface signals are set.
- Interpreter stop
- NC Start disable in this channel.
1 Alarms
1-175