Siemens SINUMERIK 840D Series Diagnostics Manual page 47

11.02
4185
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
4200
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
4210
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
 Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
Channel %1 illegal auxiliary function configured %2 %3 %4
%1 = Channel number
%2 = Type of auxiliary function
%3 = Extension
%4 = Auxiliary function value
An auxiliary function has been illegally configured.
Predefined auxiliary functions cannot be reconfigured by user-defined auxiliary functions.
- Mode group not ready.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Reconfigure the auxiliary function.
Clear alarm with the RESET key. Restart part program
Channel %1 geometry axis %2 must not be declared a rotary axis
%1 = Channel number
%2 = Axis name
The geometry axes represent a Cartesian coordinate system and therefore the declara-
tion of a geometry axis as rotary axis leads to a definition conflict.
- NC not ready.
- Mode group not ready, also effective for single axes
- NC Stop on alarm.
- NC Start disable in this channel.
- Alarm display.
- Interface signals are set.
Please inform the authorized personnel/service department. Remove rotary axis declara-
tion for this machine axis.
For this purpose, the geometry axis index for the displayed geometry axis must be deter-
mined by means of the channel-specific machine data array 20060
AXCONF_GEOAX_NAME_TAB. The channel axis number is stored with the same index
in the channel-specific MD array 20050 AXCONF_GEOAX_ASSIGN_TAB. The channel
axis number minus 1 provides the channel axis index under which the machine axis num-
ber is found in the channel-specific MD array 20070 AXCONF_MACHAX_USED.
Switch control OFF - ON.
Channel %1 spindle %2 declaration as rotary axis missing
%1 = Channel number
%2 = Axis name, spindle number
If a machine axis is to be operated as a spindle, this machine axis must be declared as a
rotary axis.
- NC not ready.
- Mode group not ready, also effective for single axes
- NC Stop on alarm.
- NC Start disable in this channel.
- Alarm display.
- Interface signals are set.
Please inform the authorized personnel/service department. Set rotary axis declaration
for this machine axis in the axis-specific MD 30300 IS_ROT_AX.
Switch control OFF - ON.
1 Alarms
1-47