Siemens SINUMERIK 840D Series Diagnostics Manual page 251

11.02
Reactions:
Remedy:
Program Continuation:
17000
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
17001
Parameters:
Definitions:
 Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
Note:
The alarm can only be generated when the simulation is
completed during the search run. The alarm cannot
be output immediately at the start of the search run.
- NC Start disable in this channel.
- NC Stop on alarm.
- Alarm display.
- Interface signals are set.
- Alarm display.
$MN_SUPPRESS_ALARM_MASK $MC_AUTO_IPTR_LOCK and language command
IPTRLOCK
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 maximum number of symbols exceeded
%1 = Channel number
%2 = Block number, label
The maximum number of symbols defined by machine data 28020
MM_NUM_LUD_NAMES_TOTAL has been exceeded.
- Alarm display.
- Interface signals are set.
- Interpreter stop
- NC Start disable in this channel.
Please inform the authorized personnel/service department.
• Modify machine data
• Reduce the number of symbols (variables, subroutines, parameters)
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 no memory left for tool/magazine data
%1 = Channel number
%2 = Block number, label
The number of the following tool/magazine data sizes in the NC is given by machine data:
• Number of tools + number of grinding data blocks: 18082 MM_NUM_TOOL
• Number of cutting edges: 18100 MM_NUM_CUTTING_EDGES_IN_TOA
Tools, grinding data blocks, cutting edges can be used independently of the tool manage-
ment function.
The memory for the following data is available only if the corresponding bit in 18080
MM_TOOL_MANAGEMENT_MASK has been set.
• Number of monitoring data sets: 18100 MM_NUM_CUTTING_EDGES_IN_TOA
• Number of magazines: 18084 MM_NUM_MAGAZINE
• Number of magazine locations: 18086 MM_NUM_MAGAZINE_LOCATION
The following size is determined by software configuration: Number of magazine spacing
data blocks: P2 permits 32 such spacing data blocks.
Definition:
• 'Grinding data blocks': Grinding data can be defined for a tool from type 400 to 499.
Such a data block occupies additional memory, as it is planned for a cutting edge.
• 'Monitoring data blocks': Each cutting edge of a tool can be supplemented by monitor-
ing data.
• 'Magazine spacing data block': Spacings to other magazines can be defined for maga-
zine locations in internal magazines.
1 Alarms
1-251