Siemens SINUMERIK 840D Series Diagnostics Manual page 124

1 Alarms
Program Continuation:
12030
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
12040
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
12050
Parameters:
1-124
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 invalid parameter or data type in %3
%1 = Channel number
%2 = Block number, label
%3 = Source string
In polynomial interpolation, polynomials must not be greater than the 3rd degree (refer to
Programming Guide).
f(p) = a0 + a1 p + a2 p2 + a3 p3
The coefficients a0 (the starting points) are identical to the end points of the preceding
block and need not be programmed. In the polynomial block, a maximum of 3 coefficients
per axis is therefore allowed (a1, a2, a3).
- Alarm display.
- Interface signals are set.
- Correction block
Press the NC Stop key and select the function "Correction block" with the soft key PRO-
GRAM CORRECT. The correction pointer positions on the incorrect block.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 expression %3 is not of data type 'AXIS'
%1 = Channel number
%2 = Block number, label
%3 = Source string in the block
Some keywords require that the data in their parameters be written in variables of the type
"AXIS". For example, in the keyword PO the axis identifier must be specified in the paren-
thesized expression, and it must be defined as a variable of the AXIS type. With the fol-
lowing keywords only parameters of the AXIS type are possible:
AX[..], FA[..], FD[..], FL[..], IP[..], OVRA[..], PO[..], POS[..], POSA[..]
Example:
N5 DEF INT ZUSTELL=Z1 incorrect, this does not specify an axis identifier but the num-
ber 26 161
N5 DEF AXIS ZUSTELL=Z1 correct
:
N10 POLY PO[X]=(0.1,0.2,0.3) PO[Y]=(22,33,44) &PO[INFEED]=(1,2,3)
- Alarm display.
- Interface signals are set.
- Correction block
Press the NC Stop key and select the function "Correction block" with the soft key PRO-
GRAM CORRECT. The correction pointer positions on the incorrect block.
Correct the part program in accordance with the instructions given in the Programming
Guide.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 DIN address %3 not configured
%1 = Channel number
%2 = Block number, label
%3 = DIN address in the source text block
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
 Siemens AG, 2002. All rights reserved
11.02