Siemens SINUMERIK 840D Series Diagnostics Manual page 240

1 Alarms
16914
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
16915
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
16916
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
16918
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
16919
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
1-240
Mode group %1 channel %2 mode change: action %3 not allowed
%1 = Channel number
%2 = Mode group number
%3 = Action number/action name
Incorrect mode change, e.g.: Auto -> MDAREF.
- Alarm display.
Check operation or selected mode.
Clear alarm with the Delete key or NC START.
Channel %1 action %2 not allowed in the current block
%1 = Channel number
%2 = Action number/action name
If traversing blocks are interrupted by asynchronous subroutines, then it must be possible
for the interrupted program to continue (reorganization of block processing) after termina-
tion of the asynchronous subroutine.
The 2nd parameter describes which action wanted to interrupt block processing.
- Alarm display.
Let the program continue to a reorganized NC block or modify part program.
Clear alarm with the Delete key or NC START.
Channel %1 repositioning: action %2 not allowed in the current state
%1 = Channel number
%2 = Action number/action name
Repositioning of block processing presently not possible. In certain cases this can prevent
a mode change from taking place.
The 2nd parameter describes which action should be used to perform repositioning.
- Alarm display.
Let the program continue to a repositioned NC block or modify part program.
Clear alarm with the Delete key or NC START.
Channel %1 for action %2 all channels must be in reset state
%1 = Channel number
%2 = Action number/action name
All channels must be in the initial setting in order to carry out the action! (For example, for
machine data loading)
- Alarm display.
Either wait until the channel status is aborted or press the Reset key.
Clear alarm with the Delete key or NC START.
Channel %1 action %2 is not allowed due to a pending alarm
%1 = Channel number
%2 = Action number/action name
This action cannot be performed due to an alarm, or the channel is in fail.
- Alarm display.
Press RESET key.
Clear alarm with the Delete key or NC START.
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
 Siemens AG, 2002. All rights reserved
11.02