Siemens SINUMERIK 840D Series Diagnostics Manual page 405

11.02
Remedy:
Program Continuation:
61804
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61805
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61806
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61807
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
 Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
Check parameter _AXN.
Check MD20050-20080.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2: Progr. position exceeds reference point
%1 = Channel number
%2 = Block number, label
The programmed intermediate position or actual position is behind the reference point.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
-
Internal
Channel %1 block %2: The value is absolutely and incrementally programmed
%1 = Channel number
%2 = Block number, label
The programmed intermediate position is both absolutely as well as incrementally pro-
grammed.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
-
Internal
Channel %1 block %2: Incorrect axis assignment
%1 = Channel number
%2 = Block number, label
The axis-assignment sequence is wrong.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
-
Internal
Channel %1 block %2 wrong spindle direction programmed (active)
%1 = Channel number
%2 = Block number, label
Alarm triggered by following cycle: CYCLE840.
The programmed spindle direction contradicts the spindle direction planned for the cycle.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Check parameters SDR and SDAC.
Clear alarm with the RESET key. Restart part program
1 Alarms
1-405