Siemens SINUMERIK 840D Series Diagnostics Manual page 191

11.02
Reactions:
Remedy:
Program Continuation:
14600
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
14601
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
14602
Parameters:
Definitions:
Reactions:
Remedy:
 Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
- Alarm display.
- Interface signals are set.
- Interpreter stop
- NC Start disable in this channel.
Check the variable types in the EXTERN and the PROC statements for correspondence
and correctness.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 reload buffer %3 cannot be established
%1 = Channel number
%2 = Block number, label
%3 = File name
The download buffer for "execute from external" could not be created. Possible causes:
• Not enough memory available (for minimum see MD
$MN_MM_EXT_PROG_BUFFER_SIZE)
• No resources available for MMC NCK communication (see MD
$MN_MM_EXT_PROG_NUM)
• The file already exists
- Alarm display.
- Interface signals are set.
- Interpreter stop
- NC Start disable in this channel.
• Release memory, e.g. by deleting part programs
• Modify MD $MN_MM_EXT_PROG_BUFFER_SIZE and/or
$MN_MM_EXT_PROG_NUM.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 reload buffer could not be deleted
%1 = Channel number
%2 = Block number, label
The reload buffer for "execute from external" could not be deleted. Possible cause: MMC/
PLC communication was not terminated.
- Alarm display.
- Interface signals are set.
- Interpreter stop
- NC Start disable in this channel.
All reload buffers are cleared on POWER ON.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 timeout during EXTCALL
%1 = Channel number
%2 = Block number, label
No connection could be established to the MMC for reloading of external subprograms
(EXTCALL) within the time set in $MN_MMC_CMD_TIMEOUT.
- Alarm display.
- Interface signals are set.
- Interpreter stop
- NC Start disable in this channel.
Requirement: MMC102/103 with software version >= P4
• Check the connection to the MMC102/103
• Increase $MN_MMC_CMD_TIMEOUT.
1 Alarms
1-191