Table of Contents
Advertisement
System Monitoring
7.5 LIMITS
Each trace can have up to five limit tests. Thus, you are given the limit test option up to five times for
each trace. Once you decline a limit test option for a trace, or you have specified all five limit tests for a
trace, the program begins the trace-entry procedure for the next trace. Once all traces have been
specified, the main menu reappears.
Limit test
1
CYoHY
The program asks if a limit test is required.
or
Press
to request a limit test, or
to begin entering the
next trace.
The prompt for the limit type depends upon the function being measured by the current trace.
For all
functions except "Digital Bit," look under the heading "Analog."
After the limit type has been specified, proceed to subsection 7. 5. 3, "Limit Actions."
7.5.1 Analog
Limit
taupe:
Low High?
The program asks if the limit should be triggered when the
measurement falls below the limit point (Low) or if the
measurement rises above the limit point (H1 ah).
or
Press
to select a low limit, or press
to select a high
limit.
Limit point?
The program prompts for the value to be compared with
each reading.
limit point [ENDLINE
Enter the limit point, and press [ENDLINEJ.
7.5.2 Digital Bit
Limit
tuped
Set
Clear?
The program asks if the limit should be triggered when the
bit is set (== 1.) or if the bit is clear (= 1 =ar).
or
Press
to select a set limit, or press
to select a clear
limit.
7-11
Advertisement
Table of Contents
