Table of Contents
Advertisement
System Monitoring
7.9 RETRIEVING TRACE SETUPS
Use the s=1. command to retrieve a setup file from storage. Note that when this command is invoked, any
currently -active setup information will be lost!
To use this command, press
from the file menu:
oe:
Yer Main
(or NJ
File mame?
file name ENDL INE
Feading. ..
Ecdit File Eun
Chait?
The file menu. Press [G] to select the Gt command.
If a trace setup currently exists, the program reminds you
that it will be destroyed.
Press
to proceed, or
to escape back to the main
menu.
The program prompts for the name of the file to read.
Enter the file name and, if needed, the optional mass
storage specifier, then press ENDLINE | .
The program displays a status message while the file is
being read.
The program returns to the main menu.
Advertisement
Table of Contents
