Table of Contents
Advertisement
The SETUP Program
9.4.1 Signals
# Digits C2, 4.
or
[3.4 or 5)
Degrees:
C0 F EE or REY
last channel?
last channel ENDLINE
blo.
burst
readings?
[Y]) or NJ
9-6
The program
prompts
for
the
number of digits of
resolution. This prompt does not appear if the function is
frequency or temperature. (Frequency measurements are
made with §. 5-digit resolution and a 1-second gate time.)
Press (3), (4), or [5)to use 3.5, 4.5, or 5.5 digits in the
HP 3421A.
If the function is temperature, the program prompts for
the desired temperature unit. Temperature measurements
are made with §. 5-digit resolution.
Press
to select Celsius units,
to select Fahrenheit
units,
to select Kelvin units, or [R] to select Rankine
units.
The
program
prompts
for
the
first channel in the
HP 3421A which should be measured.
Enter the channel number, then press ENDLINE | .
The program prompts for the last channel to be scanned.
Enter the last channel of the range to be scanned.
If the first and last channels are identical, the program
asks how many readings should be taken on that channel
in a single burst.
Enter the number of burst readings (up to 30), and press
ENDL INE J .
If a series of burst measurements are to be taken on a
single channel, the program gives you two options. The
program can retain the numerical average of the burst, or
all of the readings in the burst.
Press
to retain the average of the burst readings, or
to retain all the burst readings.
Advertisement
Table of Contents
