HP 82479A Owner's Manual page 229

ERROR AND WARNING MESSAGES
K
The following messages may be displayed or printed by the programs in the Data Acquisition Pac during
execution:
Aborted by From71
Ascending Order Only
Average Not Specified
Bad Channel In Series
Channel Not Act/Bit
Conversion Subprogram Missing
Corrupt Data
Descending Channels
Device Not Found
Dev Not Mass Storage
Device Not SS80
Directory Not Found
Disk Error:...
Disk Too Big
ERROR: Calling filename
File Exists
The Series 200 computer receiving data from the TRANSFER program
sent an abort message.
The channels for a multi-channel scan in LOG must be listed in
ascending order.
The setup file does not indicate whether a burst reading should be
averaged.
A channel series contains a channel of inappropriate type for the
measurement specified, such as a voltage measurement on channels 3
through 25 when a digital card is in slot 1.
The specified channel for a limit control action is not an actuator
channel or a digital output bit.
A conversion program specified by a setup is not in memory.
The data in the HP-71 file is unreadable.
A series of channels specified for a channel group is in descending
order.
The device specified for HP-71 file or MS-DOS file does not exist on
the loop.
The target device is not a mass storage device.
The target device does not respond to Subset/80 command protocol.
A directory specified in <path> does not exist.
An error has been detected in accessing the disc. Normally, an
explanation will follow the "". If not, the error might be in specifying a
unit number for which there is no physical disc (e.g., specifying unit 2
while talking to HPLINK on the HP 150, when there is no disk assigned
to "C:").
Disc 1s too big to be handled by MSDOSXFR program.
A problem occured while trying to call a custom program. This may be
because the custom program is not in memory or the parameters are
mismatched.
The MS-DOS file already exists on the target device.