Table of Contents
Advertisement
System Monitoring
7.13 REPLACING A TRACE
The Eepl ace command is used to replace all or part of the specifications for a trace in the current
setup. To use the R=F1 ace command, press [R] from the edit menu:
Rl
Chrno Sc
Lim Title Ext?
C.S LUO or E
soreen Little?
screen title ENDLINE
Trace?
trace number ENDLINE
*
*
Trace
p ¥$
0%
7-22
The edit menu.
Press [R] to select the R=2pl aize command.
The replace menu.
Press
to replace all the specifications for a trace. Press
[S] to replace the scale for the screen display, or LU) to
replace the limit specifications for a trace.
Press
to
replace the screen title, or (E] to return to the edit menu.
If the screen title is to be replaced, the program prompts
for the new title.
Enter the new title, up to 80 characters, and press
ENDLINE |
After the new title has been entered, the
program returns to the replace menu.
If an entire trace is to be replaced, or just the scale or
limits, the program prompts for the trace to be modified.
Enter the trace number, and press ENDLINE | .
If the entire trace is to be replaced, the program begins to
prompt for the new setup information.
Follow the same
procedure for trace entry as described under the Hei
command. After the new trace specifications have been
entered, the program returns to the replace menu.
If the scale for the trace is to be replaced, the program
prompts for the scale minimum and maximum values, and
returns to the replace menu.
If the limits are to be replaced, the program begins to
prompt
for
the
limit
test
information.
Follow
the
instructions in subsection 7.5, "Limits."
After the new
limits have been entered, the program returns to the
replace menu.
Advertisement
Table of Contents
