HP 82479A Owner's Manual page 69

File mame?
file name ENDLINE
6.3.2 Digital Functions
Strip Chart Program
If a conversion is requested, the program prompts for the
name of the file containing the subprogram.
Enter the name of the file and press [ENDLINE ].
Two digital input functions are available: digital bit, and digital byte:
Digital Bit
Charms?
input bit address [ ENDLINE |
Seale minimum
scale minimum ENDL INE
scale maximum ENDLINE
The program prompts for the input bit to be read.
Enter the address of the bit to be read, and press
ENDLINE].
The program prompts for the scaling values for the strip
chart.
Enter the value which represents the lower bound of the
scale for this trace.
Enter the value which represents the upper bound of the
scale for this trace.
Note that several digital channels can be traced in the same manner as a timing diagram. To do this
adjust the scaling parameters to place the traces side by side. For instance, set the scale for trace 1 from 0
to 11; the second trace from -1 to 10; the third trace from -2 to 9, and so on.
Digital Byte
m=lot CB, 1, op 207
@), (1)or [2]
scale minimum ENDL INE ]
The program asks which slot to read a byte from. The
readings from the digital card are returned as a decimal
value in the range 0 - 255.
Press [@), [1], or [2] to select the slot containing a digital
card.
The program prompts for the scaling values for the strip
chart.
Enter the value which represents the lower bound of the
scale for this trace.
6-5