Programmable Digital Inputs - ABB ACS355 series User Manual

134 Program features

Programmable digital inputs

The drive has five programmable digital inputs. The update time for the digital inputs
is 2 ms.
One digital input (DI5) can be programmed as a frequency input. See section
Frequency input on page 135.

Settings
Parameter
Group 10 START/STOP/DIR
Group 11 REFERENCE SELECT
Group 12 CONSTANT SPEEDS
Group 16 SYSTEM CONTROLS
Group 19 TIMER & COUNTER
2013, 2014
2109
2201
2209
3003
Group 35 MOTOR TEMP MEAS
3601
3622
4010/4110/4210
4022/4122
4027
4228
Group 84 SEQUENCE PROG

Diagnostics
Actual signal
0160
0414
Additional information
DI as start, stop, direction
DI in reference selection, or reference source
DI in constant speed selection
DI as external Run enable, fault reset or user macro
change signal
DI as timer or counter control signal source
DI as torque limit source
DI as external emergency stop command source
DI as acceleration and deceleration ramp selection
signal
DI as zero ramp force signal
DI as external fault source
DI in motor temperature measurement
DI as timed function enable signal source
DI as booster activation signal source
DI as PID controller reference signal source
DI as sleep function activation signal in PID1
DI as PID1 parameter set 1/2 selection signal source
DI as external PID2 function activation signal source
DI as Sequence programming control signal source
Additional information
DI status
DI status at the time the latest fault occurred