ABB ACS355 series User Manual page 69

Select the application macro according to which the
control cables are connected.
Continue with the application set-up. After
completing a set-up task, the Start-up assistant
suggests the next one.
OK
• Press (when
continue with the suggested task.
• Press key to highlight
OK
to move to the following task without doing the
suggested task.
EXIT
• Press to stop the Start-up assistant.
DIRECTION OF THE MOTOR ROTATION
Press to switch to local control (LOC shown on
LOC
REM
the left).
• If the drive is in remote control (REM shown on the
status line), switch to local control by pressing
• If you are not in the Output mode, press
repeatedly until you get there.
• Increase the frequency reference from zero to a
small value with key
• Press to start the motor.
• Check that the actual direction of the motor is the
same as indicated on the display (
forward and reverse).
• Press to stop the motor.
To change the direction of the motor rotation:
• Invert the phases by changing the value of
parameter 9914 to the opposite, ie, from 0 (NO) to
1 (YES), or vice versa.
• Verify your work by applying input power and
repeating the check as described above.
After the whole set-up is completed, check that there
are no faults or alarms shown on the display and the
panel LED is green and does not blink.
Start-up, control with I/O and ID run 69
is highlighted) to
Continue
and then press
Skip
.
means
FINAL CHECK
The drive is now ready for use.
REM PAR EDIT
9902 APPLIC MACRO
ABB STANDARD
[1]
EXIT
REM CHOICE
Do you want to
continue with
EXT1 reference setup?
Continue
Skip
EXIT
LOC
. xx x Hz
LOC
REM
x
EXIT
xx x %
DIR
forward
direction
LOC PAR EDIT
9914 PHASE INVERSION
[1]
CANCEL
00:00
SAVE
00:00 OK
xx.xHz
.
. x A
.
00:00 MENU
reverse
direction
YES
00:00 SAVE