I/O Settings Mode - ABB ACS355 series User Manual



I/O settings mode

In the I/O settings mode, you can:
• check the parameter settings related to any I/O terminal
• edit the parameter setting. For example, if "1103: REF1" is listed under Ain1
(Analog input 1), that is, parameter
change its value to, eg, AI2. You cannot, however, set the value of parameter
1106 REF2 SELECT
• start, stop, change the direction and switch between local and remote control.
How to edit and change parameter settings related to I/O terminals
Step Action
1. Go to the Main menu by pressing
Output mode, otherwise by pressing repeatedly
you get to the Main menu.
2. Go to the I/O settings mode by selecting I/O SETTINGS
on the menu with keys
ENTER
.
3. Select the I/O group, eg, DIGITAL INPUTS, with keys
and
display shows the current settings for the selection.
4. Select the setting (line with a parameter number) with
keys and
5. Specify a new value for the setting with keys
.
Pressing the key once increments or decrements the
value. Holding the key down changes the value faster.
Pressing the keys simultaneously replaces the displayed
value with the default value.
6. • To save the new value, press
• To cancel the new value and keep the original, press
CANCEL
.
1103 REF1 SELECT
to AI1.
MENU
and
SEL
, and press . After a brief pause, the
EDIT
, and press
SAVE
.
if you are in the
EXIT
until
, and pressing
.
and
Control panels 105
has value AI1, you can
Display
LOC MAIN MENU
PARAMETERS
ASSISTANTS
CHANGED PAR
00:00 ENTER
EXIT
LOC I/O SETTINGS
DIGITAL INPUTS (DI)
ANALOG INPUTS (AI)
RELAY OUTPUTS (ROUT)
ANALOG OUTPUTS (AOUT)
PANEL
00:00
EXIT
LOC I/O SETTINGS
-DI1-
1001:START/STOP (E1)
-DI2-
1001:DIR (E1)
-DI3-
EXIT 00:00
LOC PAR EDIT
1001 EXT1 COMMANDS
DI1,2
[2]
CANCEL 00:00 SAVE
LOC PAR EDIT
1001 EXT1 COMMANDS
DI1P,2P
[3]
CANCEL 00:00 SAVE
LOC I/O SETTINGS
-DI1-
1001:START PLS(E1)
-DI2-
1001:STOP PLS (E1)
-DI3-
EXIT 00:00
1
1
SEL