ABB ACS355 series User Manual page 317

Parameter
1106 REF2
SELECT
OUTPUT SIGNAL SOURCE SELECTION
1401 RELAY
OUTPUT 1
1501 AO1
CONTENT
SEL
SYSTEM CONTROL INPUTS
1601 RUN
ENABLE
1604 FAULT
RESET SEL
1606 LOCAL
LOCK
1607 PARAM
SAVE
1608 START
ENABLE 1
1609 START
ENABLE 2
Setting for Function/Information
fieldbus
control
COMM Fieldbus reference REF2 is used
COMM+AI when EXT2 is selected as the active
1
control location. See section
COMM*AI1
Fieldbus references
information on the alternative
settings.
COMM Enables relay output RO control by
COMM(-1) signal 0134 COMM RO
135 Directs the contents of the fieldbus
reference
analog output AO.
COMM Enables the control of the inverted
Run enable signal (Run disable)
through
(RUN_DISABLE); with the ABB
drives profile
(INHIBIT
COMM Enables fault reset through the
fieldbus
(RESET); with the ABB drives profile
5319 EFB PAR 19
COMM Local control mode lock signal
through
14 (REQ_LOCALLOC)
DONE Saves parameter value changes
SAVE... (including those made through
fieldbus control) to permanent
memory.
COMM Inverted Start enable 1 (Start
disable) through
WORD 2
COMM Inverted Start enable 2 (Start
disable) through
WORD 2
Fieldbus control with embedded fieldbus 317
on page
WORD.
0135 COMM VALUE 1
0301 FB CMD WORD 1
5319 EFB PAR 19
OPERATION).
0301 FB CMD WORD 1
bit 7 (RESET).
0301 FB CMD WORD 1
0302 FB CMD
bit 18 (START_DISABLE1)
0302 FB CMD
bit 19 (START_DISABLE2)
Modbus register
address
40003 for REF2
320 for
ABB DCU
DRV
40134 for signal
0134
40135 for signal
to 0135
ABB DCU
DRV
40001 40031
bit 3 bit 6
bit 6
bit 3
40001 40031
bit 4 bit 7 bit 4
- 40031
bit bit 14
41607
- 40032
bit 18
- 40032
bit 19