Setting Up Communication Through A Fieldbus Adapter Module - ABB ACS355 series User Manual

Setting up communication through a fieldbus adapter
module
Before configuring the drive for the fieldbus control, the adapter module must be
mechanically and electrically installed according to the instructions given in section
Attach the optional fieldbus module
The communication between the drive and the fieldbus adapter module is activated
by setting parameter
parameters in group
Parameter
COMMUNICATION INITIALIZATION
9802 COMM PROT
SEL
ADAPTER MODULE CONFIGURATION
5101 FBA TYPE
5102 FB PAR 2
... ...
5126 FB PAR 26
5127 FBA PAR
REFRESH
Note: In adapter module, the parameter group number is A (group 1) for group
COMM MODULE.
TRANSMITTED DATA SELECTION
5401 FBA DATA IN 1
... ...
5410 FBA DATA OUT
10
5501 FBA DATA OUT
...
1
...
5510
FBA DATA OUT
10
Note: In adapter module, the parameter group number is C (group 3) for group
IN and B (group 2) for group
on page 38, and the module manual.
9802 COMM PROT SEL
51 EXT COMM MODULE
Alternative
settings
NOT SEL
STD MODBUS
EXT FBA
MODBUS
RS232
-
These parameters are adapter module-specific. For more
information, see the module manual. Note that not all of these
parameters are necessarily used.
(0) DONE
(1) REFRESH
0
1...6
101...9999
0
1...6
101...9999
55 FBA DATA
Fieldbus control with fieldbus adapter 341
to EXT FBA. The adapter-specific
must also be set. See the table below.
Setting for
fieldbus
control
EXT FBA
-
-
OUT.
Function/Information
Initializes the
communication between the
drive and the fieldbus
adapter module.
Displays the type of the
fieldbus adapter module.
Validates any changed
adapter module
configuration parameter
settings.
51 EXT
Defines the data transmitted
from the drive to the fieldbus
controller.
Defines the data transmitted
from the fieldbus controller
to the drive.
54 FBA DATA