Staple Inlet Guide Height Adjustment - Canon Finisher-AB1 Service Manual

Chapter 5
6) Attach the assist stopper [1] using the 2 screws [2].
[2] [1]
F-5-99
5.3.2.15 Staple inlet guide height
adjustment
This adjustment is performed either when poor tray
stacking occurs with thin papers shown in the figure
below or when the EEPROM (IC107) on the finisher
controller PCB is replaced.
F-5-100
1) Turn on the finisher.
2) Turn on the host machine so that the machine will
be in a standby state.
3) Open the front door, and insert the door switch
actuator into the door switch [1].
5-32
[2]
0016-4796
F-5-101
4) Remove the screw [2], and detach the switch
cover [1].
[2]
F-5-102
[1]
[1]