Adjustment Of Eeprom (Ic107) On The Finisher Controller Pcb After Replacement - Canon Finisher-AB1 Service Manual

10) If A (between 1st and 2nd sheets) or B (between
2nd and 3rd sheets) is not as indicated, go through
the following:
Press the push switch SW385 [1] so that the
machine is in adjustment mode for A (between 1st
and 2nd sheets). Press the push switch SW383 [2]
to decrease the displacement, or press SW384 [3]
to increase the displacement. (The LED [4]
indicates the correction value.)
range of adjustment: +30 to -30 (unit: 0.2 mm)
SW382
SW381
SW383 SW384 SW385
(-) (+) ENTER
[2] [3]
F-5-84
11) If B (between 2nd and 3rd sheets) is not as
indicated, go through the following:
Press the push switch SW385 [1] so that the
machine is in adjustment mode for B (between 1st
and 3rd sheets).
Press the push switch SW382 [2] to decrease
the displacement, or press SW384 [3] to increase
the displacement. (The LED [4] will indicate the
correction value.)
range of adjustment: +30 to -30 (unit: 0.2 mm)
Another press on SW385 will store the A/B
correction value.
[4]
[1]
SW382
SW381
SW383 SW384 SW385
(-) (+) ENTER
[2] [3]
F-5-85
A press on the push switch SW385 while the LED is
indicating '0' will cause the LED to indicate the A
and B correction values in sequence.
Pay attention so that you remain aware of which
correction value you are working on.
5.3.2.11 Adjustment of EEPROM (IC107)
on the Finisher Controller PCB After
Replacement
Adjustments after replacing the EEPROM (IC107)
on the finisher controller PCB
These adjustments are performed when the
EEPROM (IC107) on the finisher controller PCB
has been replaced.
1) Turn on the finisher.
2) Turn on the copier and set the copier in a stand-by
mode.
3) Open the front door, and insert the door switch
actuator into the door switch [1].
Chapter 5
[4]
[1]
0015-2244
5-27