Adjusting The Delivery Of Stapled Stacks (Saddle Delivery) - Canon Finisher-AB1 Service Manual

SW382
SW381
SW383 SW384 SW385
(-) (+) ENTER
[2] [3]
F-5-85
A press on the push switch SW385 while the LED is
indicating '0' will cause the LED to indicate the A
and B correction values in sequence.
Pay attention so that you remain aware of which
correction value you are working on.
5.3.2.11 Adjusting the Delivery of Stapled
Stacks (saddle delivery)
Go through the following steps if there is
displacement (cover, 1st to 3rd sheets) among sheets
of a stapled stack (saddle delivery) or if you have
replaced the EEPROM of the finisher controller:
1) Turn on the finisher.
2) Turn on the host machine so that the machine will
be in a standby state.
3) Open the front door, and insert the door switch
actuator into the door switch [1].
[4]
[1]
0015-2239
F-5-86
4) Remove the screw [2], and detach the switch
cover [1].
[2]
F-5-87
5) Set the DIP switch SW382 [1] on the switch PCB
as follows:
[1]
SW382
SW381
SW383 SW384 SW385
(-) (+) ENTER
F-5-88
Chapter 5
[1]
5-29
[1]