Adjusting The Saddle Folding Position - Canon Finisher-AB1 Service Manual

Chapter 5
11) Press the push switch (SW383, SW384)
according to the degree of displacement from the
standard.
A press on SW383 [1] will move the stapling
position upward, while a press on SW384 [2] will
move it downward.
range of adjustment: +5 to -5 (unit: 0.2 mm)
SW382
SW381
SW383 SW384 SW385
(-) (+) ENTER
[1] [2]
F-5-102
5.3.2.13 Adjusting the Saddle Folding
Position
Go through the following steps if there is
displacement in folding position (saddle delivery) or
if you have replaced the EEPROM of the finisher
controller PCB:
1) Turn on the finisher.
2) Turn on the host machine so that it will be in a
standby state.
3) Set the machine for a set of 20 sheets on the
control panel, and execute printing.
4) Spread open the bound booklet, and measure the
following position [2] in relation to the stapling
position [1].
If the measurement is as indicated (i.e., C is 0.5 mm
or less), end the adjustment. Otherwise, go through
the following:
5-34
[C]
5) Open the front door, and insert the door switch
actuator into the door switch [1].
6) Remove the screw [2], and detach the switch
cover [1].
0015-2241
[1]
F-5-103
F-5-104
[1]
[2]
F-5-105
[2]
[1]