Canon Finisher-AB1 Service Manual page 379

SW383 [2] will decrease the displacement, while
a press on SW384 [3] will increase the
displacement. (The LED [4] will indicate the
correction value.)
range of adjustment: +30 to -30 (unit: 0.2 mm)
SW382
SW381
SW383 SW384 SW385
(-) (+) ENTER
[2] [3]
F-5-92
11) If B (between 1st and 3rd sheets) is not as
indicated, go through the following:
Press the push switch SW385 [1] so that the
machine is ready fro adjustment of B (cover,
between 1st and 3rd sheets).
A press on the push switch SW383 [2] will
decrease the displacement, while a press on
SW384 [3] will increase the displacement. (The
LED [4] will indicate the correction value.)
range of adjustment: +30 and -30 (unit: 0.2 mm)
Another press on SW385 will store the new A/B
correction value.
[4]
[1]
SW382
SW381
SW383 SW384 SW385
(-) (+) ENTER
[2] [3]
F-5-93
A press on the push switch SW385 while the LED is
indicating '0' will cause the LED to indicate the A
and B correction values in sequence.
Pay attention to remain aware of which correction
value you are working on.
Chapter 5
[4]
[1]
5-31