Canon Finisher-AB1 Service Manual page 372

Chapter 5
5.3.2.9 Adjusting the Stapling Position (2-
point)
Go through the following steps if there is
displacement in stapling position (2-point) or if you
have replaced the EEPROM of the finisher controller
PCB:
1) Turn on the finisher.
2) Turn on the host machine so that it will be in a
standby state.
3) Open the front door, and insert the door switch
actuator into the door switch [1].
F-5-69
4) Remove the screw [2], and detach the switch
cover [1].
[2]
F-5-70
5) Set the DIP switch SW382 [1] on the switch PCB
as follows:
for A-Series,
5-24
[1]
[1]
0015-2237
SW382
SW381
SW383
(-)
[1]
for L-Series,
[1]
SW382
SW381
SW383
(-)
SW384 SW385
(+) ENTER
F-5-71
SW384 SW385
(+) ENTER
F-5-72