Adjusting The Saddle Binding Position - Canon Finisher-AB1 Service Manual

Chapter 5
5.3.2.12 Adjusting the Saddle Binding
Position
Go through the following steps if there is
displacement in stitching position (saddle delivery)
or if you have replaced the EEPROM of the finisher
controller PCB:
1) Turn on the finisher.
2) Turn on the host machine so that it will be in a
standby state.
3) Open the front door, and insert the door switch
actuator into the door switch [1].
F-5-94
4) Remove the screw [2], and detach the switch
cover.
[2]
F-5-95
5-32
[1]
5) Set the DIP switch DIP SW382 [1] on the switch
PCB as follows:
- for A-Series, [2]
- for L-Series, [3]
0015-2240
[1]
SW382
SW381
SW383
[1]
(-)
6) Hold the lever [1], and slide out the saddle unit
[2]; then, open the saddle right guide [3].
[2]
[1]
SW384 SW385
[2]
(+) ENTER
[3]
F-5-96
[3]
F-5-97