Canon Finisher-AB1 Service Manual page 370

Chapter 5
5) Set the DIP switch SW382 [1] on the switch PCB
as follows:
for A-Series,
[1]
SW382
SW381
SW383 SW384 SW385
(-) (+) ENTER
F-5-62
for L-Series,
[1]
SW382
SW381
SW383 SW384 SW385
(-) (+) ENTER
F-5-63
6) Press the push switch SW385 [1] to start
adjustment of the stapling position (front 1-
point).
5-22
SW382
SW381
SW383 SW384 SW385
(-) (+) ENTER
F-5-64
7) Press the push switch SW383 [1] or SW382 [3] to
store the new adjustment value.
A press on SW383 causes the LED [3] to
indicate '-1', moving the stapling position (front
1-point) toward the rear. On the other hand, a
press on SW384 causes the LED [3] to indicate
'+1', moving the stapling position toward the
front.
range of adjustment: +20 to -20 (unit: 0.5 mm)
SW382
SW381
SW383 SW384 SW385
(-) (+) ENTER
[1] [2]
F-5-65
[1]
[3]