Electrical System; Finisher Controller Pcb; Static Charge Eliminator - Canon Finisher-AB1 Service Manual

Chapter 4

4.5 Electrical System

4.5.1 Finisher Controller PCB

4.5.1.1 Finisher Controller PCB

4.5.1.1.1 Before Removing the Finisher
Controller PCB
1) Remove the middle rear cover.
2) Remove the lower rear cover.
4.5.1.1.2 Removing the Finisher Controller PCB
1) Remove the finisher controller PCB [1].
(page 5-11)Reference[Adjusting the Angle of
the Aligning Plate (orthogonal)]
(page 5-12)Reference[Adjusting the Speed of
the Swing Guide]
(page 5-13)Reference[Adjusting the Aligning
Plate Width]
(page 5-17)Reference[Adjusting the Stapling
Position (rear 1-point)]
(page 5-20)Reference[Adjusting the Stapling
Position (front 1-point)]
(page 5-22)Reference[Adjusting the Stapling
Position (2-point)]
(page 5-25)Reference[Adjusting the Delivery of
Stapled Stacks (lower delivery)]
- 24 connectors (all)
- 4 screws [2]
[2]
F-4-108
4-28
0015-2193
0016-3519
[1]
[2]

4.5.2 Static Charge Eliminator

4.5.2.1 Removing the Stack Edging Roller
Static Eliminator
1) Remove the 2 stack edging roller stack eliminators
[1].
- 4 screws [2]
[2]
F-4-109
4.5.2.2 Before Removing the Static
Eliminator (upper delivery slot)
1) Remove the upper rear cover (right). (page 4-
2)Reference[Removing the Upper Rear Cover
(right)]
2) Remove the upper rear cover (left). (page 4-
3)Reference[Removing the Upper Rear Cover
(left)]
3) Remove the middle rear cover. (page 4-
6)Reference[Removing the Middle Rear Cover]
4) Remove the upper cover unit. (page 4-
3)Reference[Removing the Upper Cover Unit]
[1] [2]
0015-2194
0015-2195