Making Adjustments; Making Check And Adjustment Of The Height - Canon Staple Finisher-AA1 Service Manual

Making Adjustments

The difference in height between the Finisher and the Host
Machine and the tilt of the Finisher and the Host Machine
need to be adjusted depending on the installation site floor
condition. If the height or tilt is not adjusted properly,
problems can occur (for example, a paper jam can occur
frequently at the paper supply section of the Finisher). Check
the height and tilt and adjust it as required. Be sure to adjust
as necessary.
Making Check and Adjustment
of the Height
1.
Check the difference in height between the Finisher
and the Host Machine. Make sure that the pin of the
Buffer Pass Unit inserts into the hole of the Finisher.
In the case the pin of Buffer Pass Unit is inserted into
the hole of the Finisher, this adjustment is not
required.
NOTE:
When the adjustment of height is not necessary, proceed
to the "Making Check and Adjustment of the Tilt".
2.
209
7. Installation