Canon Finisher-AB1 Service Manual page 137

3) Place the A4 or letter size sheets [1] in the
intermediate processing tray in the direction of the
arrow. Then, measure the degree of displacement [A]
between the paper edge stopper [2] and the assist
stopper [3].
If the measured value (+A or -A) is outside of the
reference value (0+0.5 mm), perform the adjustment
to make the degree of displacement falls within the
range of the reference value.
[1] [2]
[1] [2]
F-5-96
[1]
+A
[3] [2]
-A
[3] [2]
4) Remove the 2 screws [2], and remove the assist
stopper [1].
[2] [1]
F-5-97
5) Loosen the screw [1] of the assist stopper, and
adjust it so that the degree of displacement of the
stopper [2] falls within the range of the reference
value [3].
[2]
[1]
F-5-98
If the measured value [3] obtained in the step 3
is -A, move the stopper [2]
of the white arrow, on the other hand, if it is
+A, move in the direction of the black arrow.
Chapter 5
[2]
T-5-5
in the direction
5-31
[3]