Canon Finisher-AB1 Service Manual page 383

7) Set the DIP switch DIPSW382 [1] on the switch
PCB as follows:
[1]
SW382
SW381
SW383 SW384 SW385
(-) (+) ENTER
F-5-106
6) Obtain the correction
measurement, and press the 2 push switches
(SW383, SW384) as necessary to correct.
A press on SW383 [1] will move the folding
position [2] upward, while a press on SW 384 [3]
will move it downward.
range of adjustment: +30to -30 (unit: 0.1 mm)
value from the
SW382
SW381
SW383 SW384 SW385
(-) (+) ENTER
[1] [3]
[2]
F-5-107
9) Press the push switch SW385 once to end
adjustment mode.
Chapter 5
5-35