Canon Finisher-AB1 Service Manual page 160

Chapter 5
DIP setting
SW382
SW382
SW382
SW382
SW382
SW382
SW382
SW382
5-54
Item
driving the drive switchover
motor
driving tray pickup motor
driving the feed motor
driving the tray A lift motor Press ENTER to start (1100 mms/sec). Press ENTER to
driving the tray B lift motor
driving the tray registration
clutch
Ageing
checking the sensors 1
T-5-8
Description
Press ENTER to start. A press on + will start tray A,
while a press on - will start tray B. Press ENTER to end.
Press ENTER to start. A press on +/- will switch over the
speed (250, 500, 1100 mm/sec). Press ENTER to end.
Press ENTER to start (1100 mm/sec). Press ENTER to
end.
end.
Press ENTER to start. It will stop automatically. (ON for
500 msec)
Press ENTER to start and repeat the following
operations; press ENTER to end:
tray A up>50 sheets in tray A>tray A down>tray B
up>50 sheets in tray B>tray B down
Press ENTER to start. A press on +/- switches over
sensors. Press ENTER to end.
1. tray A paper placement sensor
2. tray A pickup sensor
3. tray A registration sensor
4. tray A paper sensor
5. tray B paper sensor 1
6. tray B paper sensor 2
7. tray B paper placement sensor
8. tray B pickup sensor
9. tray B registration sensor
A press on the + switch to start the sensor in question.
The sensor in question is indicated on the display
(DSP381). If the sensor operation is normal, 1 goes on in
response to the placement of paper, while it flashes when
the paper is removed.