Saddle Staple Alignment Adjustment - Canon Finisher-AB1 Service Manual

Chapter 5
6) The preparations for this adjustment are
completed by pressing the push switch SW385
[1].
SW382
SW381
SW383 SW384 SW385
(-) (+) ENTER
F-5-172
7) When the push switch SW384 [1] is pressed once,
"+1" appears on the LED [2].
SW382
SW381
SW383 SW384 SW385
(-) (+) ENTER
[1]
F-5-173
8) This adjustment is completed when the push
switch SW385 [1] is pressed again.
5-52
[1]
[2]
SW382
SW381
SW383 SW384 SW385
(-) (+) ENTER
F-5-174
5.3.2.26 Saddle staple alignment
adjustment
Be careful not to touch any of the drive parts
when checking the adjustment since this job is
done with no covers in place and with the
finisher running.
This adjustment is performed either when the saddle
staple unit is replaced or when the staple positions
(saddle delivery) at the front and the rear are
misaligned.
The operation procedure is described below.
1) Open the front door.
- 1 knob [2]
- 2 screws [3]
[1]
T-5-8
0016-4897