Adjusting The Stapling Position (Front 1-Point); Adjusting The Stapling Position (2-Point) - Canon Finisher-AB1 Service Manual

Chapter 5
5.3.2.8 Adjusting the Stapling Position
(front 1-point)
Go through the following steps if the stapling
position (front 1-point) is displaced or if you have
replaced the EEPROM of the finisher controller
PCB:
1) Turn on the finisher.
2) Turn on the host machine so that it will be in a
standby state.
3) Open the front door, and insert the door switch
actuator into the door switch [1].
F-5-60
4) Remove the switch [2], and detach the switch
cover [1].
[2]
F-5-61
5) Set the DIP switch SW382 [1] on the switch PCB
as follows:
for A-Series,
5-20
[1]
0015-2233
SW382
SW381
SW383
(-)
[1]
for L-Series,
SW382
SW381
SW383
(-)
[1]
SW384 SW385
(+) ENTER
F-5-62
[1]
SW384 SW385
(+) ENTER
F-5-63