Tray Shift Motor - Canon Finisher-AB1 Service Manual

Chapter 4
6) Loosen the screw [1], and free the belt [2] from the
gear [3].
[3]
7) Remove the aligning motor (rear) [1].
(page 5-12)Reference[Adjusting the Angle of
the Aligning Plate (orthogonal)]
(page 5-15)Reference[Adjusting the Aligning
Plate Width]
- 1 clamp [2]
- 2 cable guides [3]
- 1 connector [4]
- 2 screws [5]
[3]
[1]
[5]
4-12
[2] [1]
F-4-45
[2] [4]
F-4-46

4.3.5 Tray Shift Motor

4.3.5.1 Removing the Tray A/B Lift Motor
1)Remove the tray A/B cover [1].
- 4 screws [2]
[1]
F-4-47
2) While supporting the tray from below, release the
roll [1] in the direction of the arrow; then, move it
down until it stops.
[1]
F-4-48
0015-2304
[2]