Saddle Staple Unit - Canon Finisher-AB1 Service Manual

Chapter 4
4.3 Drive System
4.3.1 Staple Unit
4.3.1.1 Before Removing the Stapler
1) Open the front cover.
2) Open the upper cover unit.
3) Remove the inside cover (upper). (page 4-
7)Reference[Removing the Inside Cover (upper)]
4) Remove the inside cover (lower). (page 4-
7)Reference[Removing the Inside Cover (lower)]
4.3.1.2 Removing the Stapler
1) Remove the switch PCB [1].
- 2 screws [2]
- 1 connector [3]
- 1 edge saddle [4]
[2]
[3]
[1]
F-4-27
2) Push in the stapler unit [1] until it is as shown.
F-4-28
4-8
3) Remove the stapler unit [1]. (page 5-
13)Reference[Adjusting the Stapler Position]
- 1 connector [2]
- 2 screws [3]
0015-2125
Be sure to take note of the positioning index [4]
before detaching the staple.
0015-2126
[4]
[4]

4.3.2 Saddle Staple Unit

4.3.2.1 Removing the Saddle Stapler Unit
1) Open the front cover.
2) Slide out the saddle unit.
3) Open the saddle stack guide[1].
[1]
[1]
[3]
F-4-29
F-4-30
[1]
[2]
0015-2127