Adjusting The Delivery Of Stapled Stacks (Lower Delivery) - Canon Finisher-AB1 Service Manual

10) Check to see that the stapling position is as
follows [1] as the result of the foregoing steps: for
A-Series, 86.3 +/-4 mm; for L-Series, 73.7 +/-4
mm. Otherwise, go back to step 6).
[1]
F-5-77
If the LED indicates other than '0', the adjustment is
likely to have failed. Start over.
5.3.2.10 Adjusting the Delivery of Stapled
Stacks (lower delivery)
Go through the following steps if there is
displacement among sheets of a stapled stack (lower
delivery; cover, 1st to 3rd sheets) or if you have
replaced the EEPROM of the finisher controller
PCB:
1) Turn on the finisher.
2) Turn on the host machine so that it will be in a
standby state.
3) Open the front door, and insert the door switch
actuator into the door switch [1].
F-5-78
4) Remove the screw [2], and detach the switch
cover [1].
5) Set the DIP switch SW382 [1] on the switch PCB
as follows:
SW382
0015-2238
SW381
SW383
(-)
[1]
[1]
[2]
F-5-79
[1]
SW384 SW385
(+) ENTER
F-5-80
Chapter 5
5-25