Canon Finisher-AB1 Service Manual page 366

Chapter 5
6) Press the push switch SW385 [1] to start
adjustment of the transport belt position.
SW382
SW381
SW383 SW384 SW385
(-) (+) ENTER
F-5-48
7) Press the push switch SW383 [1] or SW384 [2] to
store the adjustment value.
A single press on SW383 will cause the LED to
indicate '-1', closing up the distance between the
belt [4] and the paper [5] and, thus, increasing the
retention by the belt. On the other hand, a single
press on SW384 will cause the LED to indicate
'+1', distancing the belt [4] and the paper [5] and,
thus, decreasing the retention by the belt. (range:
+4 to -4)
Reference:
1. If wear has occurred on the transport belt or
recycled paper (i.e., with high surface resistance)
is used, select a negative adjustment value (-1 to -
4) to increase the retention.
2. If dents have occurred in the edge of paper,
select a positive adjustment value (+1 to +4) to
decrease the retention.
5-18
[1]
[1]
[3]
SW382
SW381
SW383 SW384 SW385
(-) (+) ENTER
[2]
[5]
F-5-49
[4]