10) Check that there is no gap between the paper and
the aligning plate as the result of the foregoing
steps. If there still is a gap, go back to step 8).
F-5-44
5.3.2.6 Adjusting the Transport Belt
Position
Go through the following steps if you have replaced
the transport belt of the intermediate tray or there is
displacement among the sheets of a delivered stack:
1) Turn on the finisher.
2) Turn on the host machine so that it will be in a
standby state.
3) Open the front door, and insert the door switch
actuator into the door switch [1].
F-5-45
4) Remove the screw [2], and detach the switch
cover [1].
[1]
[2]
0015-2231
[1]
[2]
F-5-46
5) Set the DIP switch SW382 [1] on the switch PCB
as follows:
[1]
SW382
SW381
SW383
SW384 SW385
(-)
(+)
ENTER
F-5-47
Chapter 5
[1]
5-17