Table of Contents
Advertisement
Chapter 5
5.3.2.3 Adjusting the Stapler Position
Go through the following steps if you have replaced
the stapler unit found in the intermediate handling
tray assembly:
1) Mark the position [1] of the stapler unit before
replacement.
2) Mount the new stapler unit [2] with reference
to the marking [1], fixing it in place using 2
screws [3].
[1]
[3]
F-5-31
5-12
0015-2227
[2]
5.3.2.4 Adjusting the Speed of the Swing
Guide
Go through the following steps if you have replaced
the swing guide motor or the EEPROM of the
finisher controller PCB:
1) Turn on the finisher.
2) Turn on the host machine so that it will be in a
standby state.
3) Open the front door, and insert the door switch
actuator into the door switch [1].
F-5-32
4) Remove the screw [2], and detach the switch
cover [1].
[2]
F-5-33
[1]
0015-2229
[1]
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
