Canon Finisher-AB1 Service Manual page 447

Chapter 6
Code Detail Occurrence
code classification
- Occurrence classification
02: Finisher (including inserter, puncher, trimmer)
11: POD deck 12: Secondary POD deck
51: Stacker 52: Secondary stacker
- When turning ON the power, be sure to turn ON the power in the following order: pickup/delivery accessories ->
Main Body: Otherwise the pickup/delivery accessories are not recognized.
E578 Rollette malfunction
8001 02
8002 02
E57A Paper edge stopper operation malfunction
8001 02
8002 02
8003 02
E57B Paper trailing edge retainer operation malfunction
8001 02
8002 02
Upper guide operation malfunction
E57C
8001 02
8002 02
6-8
Description
Feed belt HP sensor does not come
ON within 5 sec. after feed belt shift
motor operation begins.
Feed belt HP sensor does not go OFF
within 5 sec. after feed belt shift
motor operation begins.
Paper edge area HP sensor does not
come ON within 5 sec. after paper
edge stopper motor operation begins.
Paper edge area HP sensor does not
go OFF within 5 sec. after paper edge
stopper motor operation begins.
Paper edge stopper is obstructed by
stapler and cannot operate.
Paper trailing edge retainer HP
sensor does not come ON within 5
sec. after paper trailing edge motor
operation begins
Paper trailing edge retainer HP
sensor does not come OFF within 5
sec. after paper trailing edge motor
operation begins
Upper guide HP sensor does not
come ON within 5 sec. after upper
guide motor operation begins. .
Upper guide HP sensor does not go
OFF within 5 sec. after upper guide
motor operation begins. .
Treatment/ detection timing
- Check feed belt shift motor and feed belt HP sensor
connectors.
- Replace feed belt shift motor and feed belt HP
sensor.
-Replace the finisher controller PCB.
- Check feed belt shift motor and feed belt HP sensor
connectors.
- Replace feed belt shift motor and feed belt HP
sensor.
-Replace the finisher controller PCB.
- Check the paper edge stopper shift motor and paper
edge area HP sensor connectors.
- Replace the paper edge stopper shift motor and
paper edge area HP sensor.
-Replace the finisher controller PCB.
- Check the paper edge stopper shift motor and paper
edge area HP sensor connectors.
- Replace the paper edge stopper shift motor and
paper edge area HP sensor.
-Replace the finisher controller PCB.
- Check paper edge stopper shift motor connectors.
- Replace paper edge stopper shift motor.
-Replace the finisher controller PCB.
-Check paper trailing edge retainer motor and paper
trailing edge retainer HP sensor connectors.
-Replace paper trailing edge retainer motor and paper
trailing edge retainer HP sensor.
-Replace the finisher controller PCB.
-Check paper trailing edge retainer motor and paper
trailing edge retainer HP sensor connectors.
-Replace paper trailing edge retainer motor and paper
trailing edge retainer HP sensor.
-Replace the finisher controller PCB.
- Check upper guide motor and upper guide HP sensor
connectors.
- Replace upper guide motor and upper guide HP
sensor.
-Replace the finisher controller PCB.
- Check upper guide motor and upper guide HP sensor
connectors.
- Replace upper guide motor and upper guide HP
sensor.
-Replace the finisher controller PCB.