Adjusting The Stapling Position (2-Point) - Canon Finisher-AB1 Service Manual

9) Place A4 paper [1] in the intermediate handling
tray. (Be sure to butt the paper against the rear of
the handling tray.)
Thereafter, press the push switch SW385 to
execute stapling.
F-5-58
10) Check to see that the stapling position is 5 +/-2
mm [1] as a result of the foregoing steps.
Otherwise, go back to step 6).
[1]
F-5-59
If the LED indicates a value other than '0', the
adjustment is likely to have failed. Start over.
5.3.2.8 Adjusting the Stapling Position
(front 1-point)
Go through the following steps if the stapling
position (front 1-point) is displaced or if you have
replaced the EEPROM of the finisher controller
PCB:
1) Turn on the finisher.
2) Turn on the host machine so that it will be in a
standby state.
3) Open the front door, and insert the door switch
[1]
actuator into the door switch [1].
4) Remove the switch [2], and detach the switch
cover [1].
Chapter 5
F-5-60
[1]
[2]
F-5-61
0015-2233
[1]
5-21