Supply Item
Standard Staple Cartridge and
Staple Waste Container
Finisher Module Maintenance Procedures
For detailed instructions on maintaining the Finisher Module, refer to the following
procedures:
•
Replacing the Standard Staple Cartridge
•
Replacing the Staple Waste Container
•
Emptying the Punch Waste Container
Standard Finisher Plus Problem Solving
Fault Codes - Standard Finisher Plus
Fault Code
Possible Cause
013-108 to 013-110
The sensor or exit sensor in the
Finishing Transport did not
switch ON or did not switch OFF
within a specified amount of
time
013-910, 013-911
Paper jam at the transport
sensor or exit sensor (Finishing
Transport)
®
®
Xerox
Versant
80 Press
User Guide
Supply Unit Shipped with finisher/Reorder Quantity
4 staple cartridges (5000 staples per cartridge) and 1 staple
waste container per carton
Recommended Solution
1.
Check for any obstructions or
paper jams in the Finishing
Module and Finishing Transport
paper paths and clear them.
2.
If necessary, power Off / On the
press and rescan or resend your
job.
3.
If the fault persists, contact the
Customer Support Center.
1.
Check for any obstructions or
paper jams in the Finishing
Module and Finishing Transport
paper paths and clear them.
2.
If necessary, power Off / On the
press and rescan or resend your
job.
3.
If the fault persists, contact the
Customer Support Center.
Standard Finisher Plus
26-5